This listing was posted on ApplicantPRO.
Electronic Technician - Quality Control
Location:
Seneca, PA
Description:
Quality Control Electronic Technician Job Duties: Observe ESD precautions to prevent damage to sensitive equipment. Visually inspect assemblies to determine if they are built to customer specifications. Identify faulty components, components installed incorrectly, and detect other quality defects. Perform electronic testing of assemblies of basic to intermediate complexity. Be able to disassemble and re-assemble units correctly. Perform basic electronic/ functional troubleshooting for assemblies of basic to intermediate complexity that do not pass the accepted test procedures. Adjust or replace defective components to meet established standards. Identify, prepare and correctly solder components to PC board. Become solder certified. Assemble prototype units. Maintain accurate records on paper and/or computer. Show competency in Matric Limited part numbering system. Practice safe work habits and report all safety hazards to the supervisor. Responsible for inspecting your work and identifying quality defects. Accountable for the quality and quantity of your work. Assist co-workers with problems encountered. Shall be instrumental in improving processes and in creative problem-solving. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions Competencies To perform this job successfully, an individual must be able to perform each essential duty satisfactorily. The requirements listed below are representative of the knowledge, skill, and/or ability required. Shall be familiar with and able to use the following hand tools: screwdriver, pliers, wire cutter, wire stripper, various small wrenches, etc. Shall be familiar with and able to use the following dimensional measuring tools: ruler, vernier caliper. Shall be familiar with and able to use the following electronic test equipment: variable autotransformer, volt-ohm-milliamp meter, oscilloscopes, power suppliers, hipot tester, impedence bridge, proprietary test equipment, signal generators, frequency counters, waveform generators, various analog and digital test sets, chip programmers. Able to read and interpret engineering drawings, schematic diagrams, and formulas and confer with management or engineering staff to determine quality and reliability standards. Required Education and Experience High school or GED. Accepted electronics training - degree, technical certificate, vocational schooling and/or accepted correspondence course. Any equivalent combination of education and experience Job Posted by ApplicantPro
Company:
Matric
Posted:
April 24 on ApplicantPRO
Visit Our Partner Website
This listing was posted on another website. Click here to open: Go to ApplicantPRO
Important Safety Tips
- Always meet the employer in person.
- Avoid sharing sensitive personal and financial information.
- Avoid employment offers that require a deposit or investment.
To learn more, visit the Safety Center or click here to report this listing.
More About this Listing: Electronic Technician - Quality Control
Electronic Technician - Quality Control is a Quality Assurance Quality Control Job at Matric located in Seneca PA. Find other listings like Electronic Technician - Quality Control by searching Oodle for Quality Assurance Quality Control Jobs.
Electronic Technician - Quality Control is a Quality Assurance Quality Control Job at Matric located in Seneca PA. Find other listings like Electronic Technician - Quality Control by searching Oodle for Quality Assurance Quality Control Jobs.